Starting The Wintex 1000; Interrupting The Process; Replacement Of Probe - Wintex Agro WINTEX 1000 Instruction Manual

1. STARTING THE WINTEX 1000

2. INTERRUPTING THE PROCESS

3. REPLACEMENT OF PROBE

Start the ATV, and deactivate the emergency stop. The red button must be up.
Activate the foot switch and the brake handle on the steering wheel, and shortly push the button
at your right hand. Foot switch and brake lever must be activated during the entire process. If
one of these switches is released, the process will stop.
Note: The emergency stop must always be activated at long stops, or the battery might be
discharged.
The WINTEX 1000 has three programs.
Program 1: The soil sampler's standard program.
Program 2: The probe conducts an extra rotation.
Program 3: The probe moves up and down without rotation.
Due to various reasons it might be necessary to interrupt the process. In this case deactivate the foot
switch, and the process will stop immediately. When reactivating the foot switch and the brake handle
at the same time, the probe will go back into start position.
The emergency stop must be activated, and the ATV must be turned off.
Use two 27 mm keys to loosen the probe.
The probe is mounted correctly when the slit of the probe points towards the soil box when the rotation
stops.
Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted
+45 97990800, contact@wintexagro.com, www.wintexagro.com
P A G E | 3