Before starting the WINTEX1000s please make sure that nobody is present within a range of 10 meters. When inspecting the WINTEX 1000s, you must always activate the emergency stop, and the vehicle must be turned off. Every time you start the WINTEX 1000s, you must test the emergency stop.
P A G E 1. STARTING THE WINTEX 1000s Start the ATV, and deactivate the emergency stop. The red button must be up. Activate the foot switch and the brake on the handle bar, and shortly push the button at your right hand.
Unscrew the three bolts. The revolving platform can now be pulled down along the probe. Caution: The probe has sharp edges! Remove the coupling nut with the special key which is delivered together with the WINTEX 1000s. It is now possible to remove the probe.
Page 5
This valve is for adjusting the main pressure. The main pressure is pre-set on 120 bar. It must only be adjusted after signing a written agreement with Wintex Agro. Fuse: There is a 7.5 amp fuse for current control in the box and a 15 amp fuse for the oil cooler.
Page 6
When turning to the right, the probe will slow down. The adjusting screw must be set to 50 r.p.m. Press the button down. Turn it to the left so that it stays down. Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted +45 97990800, contact@wintexagro.com, www.wintexagro.com...
Wait until the temperature of the oil has lowered. In extremely hot areas, or if the oil temperature would become a problem, shift to another oil type. Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted +45 97990800, contact@wintexagro.com, www.wintexagro.com...
Page 8
P A G E 9. ELECTRICITY BOX Connection of wires in the electricity box Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted +45 97990800, contact@wintexagro.com, www.wintexagro.com...
Page 9
P A G E 10. HYDRAULICS Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted +45 97990800, contact@wintexagro.com, www.wintexagro.com...
Exchange after 500 hours in use and at least once a year: 10000002 Hydraulic oil filter 10000002 Hydraulic oil Exchange if necessary: 15101196 Oil level rod with filter cap Honda GX200 motor: See instruction manual Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted +45 97990800, contact@wintexagro.com, www.wintexagro.com...
| 11 12. PROBLEM SOLVING PROBLEM CAUSE POSSIBLE SOLUTIONS The WINTEX 1000s does not start soil 1) The fuse is blown. 1) Replace the fuse with a new 7.5 amp fuse. sampling. 2) The emergency stop is activated. 2) Deactivate the emergency stop.
Page 12
3) Charge the accumulator with nitrogen or 3) The accumulator pressure is too low. replace it. 4) Check the power source, the hoses and the 4) The return pressure is too high. filter. Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted +45 97990800, contact@wintexagro.com, www.wintexagro.com...
Page 13
If the accumulator is in order, you can hear a whistling sound of Nitrogen. In this case merely recharge the accumulator. If there is no whistling sound, the diaphragm is probably damaged and must be replaced. Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted +45 97990800, contact@wintexagro.com, www.wintexagro.com...
Remove both hoses. Unbolt the engine and the tank. Remember the bolt under the tank. Slide the engine and the tank out under the cooler bracket and unbolt the engine. Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted +45 97990800, contact@wintexagro.com, www.wintexagro.com...
Page 15
P A G E | 15 Move the tank into an upright position. Unscrew the pump. Replace the filter with a new one. Clean the tank thoroughly. Then remount pump, tank and engine. Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted +45 97990800, contact@wintexagro.com, www.wintexagro.com...
Need help?
Do you have a question about the 1000S and is the answer not in the manual?
Questions and answers