Step 5: Verify The Settings; Connecting The Controller To The Network; Logging On To The Web Interface - Ruckus Wireless SmartZone 100 Getting Started Manual

Running the Setup Wizard and Logging On to the Web Interface

Step 5: Verify the Settings

Step 5: Verify the Settings

Verify that all the settings displayed on the Confirmation page are correct. If they are all correct, click Finish to apply the settings
and activate the controller on the network.
FIGURE 24 Review the settings you have configured
A progress bar appears and displays the progress of applying the settings, starting the controller's services, and activating the
controller on the network.
When the process is complete, the progress bar shows the message 100% Done. The page also shows the IP address through
which you can access the controller's web interface to manage the appliance.
Congratulations! You have completed the Setup Wizard. You are now ready to log on to the controller's web interface.

Connecting the Controller to the Network

Follow these steps to connect the controller to the network.
1. Connect Port 1 to the router or switch.
2. Connect Port 2 to another router or switch to which other controllers (if present) are connected.
NOTE
Depending on your network setup, you may also connect Port 2 to the same router or switch to which Port 1 is
connected.

Logging On to the Web Interface

You can access the controller's web interface from any computer that is on the same subnet as the Management (Web) interface,
which you configured in Step 3: Configure the IP Settings
Follow these steps to log on to the controller's web interface.
1. On a computer that is on the same subnet as the Management (Web) interface, start a web browser.
38
on page 31.
Ruckus SmartZone 100 Getting Started Guide, 5.1.1
Part Number: 800-72267-001 Rev A