Group Objects Channel A - ABB i-bus KNX AA/A 2.1.2 Product Manual

®
ABB i-bus KNX
Commissioning
3.3.3.2

Group objects Channel A

No.
10
This group object is always enabled if the parameter Type of output in
deactivated.
It reflects the status of the output (output value) in the form of the user-selected input value format.
The following values can be sent:
11
This group object is enabled if the parameter Enable function Dimming in
Yes.
For the group object to be sent, the parameter Send status values in
On change.
It shows whether the input value has a higher value than the lowest threshold in the defined input range. The value is set to
"On" (1) if a new value is written via the group object Input value, or if the output is switched on using the object Dimming,
or if the output is switched on using the object Switch.
20
This group object is enabled unless the parameter Activate cyclical parameter in
set to No.
It shows whether the monitoring time for cyclical monitoring has expired and if the output has therefore been switched to
the value set for this eventuality.
Telegram value:
21
This group object is enabled unless the parameter Type of output in
It shows whether there is a fault at the output.
Telegram value:
22
This group object is enabled unless the parameter Type of output in
Depending on the output type (voltage or current) the DPT is set accordingly:
voltage, DPT 9.020/current, DPT 9.021.
The group object contains the physical output value for the channel present at the output.
Function
Status Actual value
1-byte value [0...100] %
1-byte value [0...+255]
1-byte value [-128...+127]
2-byte value [0...+65,535]
2-byte value [-32,768...+32,767]
2-byte value (floating point)
4-byte value (IEEE float. point)
Status Switch
Alarm
0 = Cyclical monitoring time has not been exceeded
1 = Cyclical monitoring time has been exceeded
Fault at output
0 = No fault at output
1 = Fault at output
Voltage output value
Current output value
Object name
Channel A
Parameter window A:
DPT 5.001
DPT 5,005
DPT 6.010
DPT 7.001
DPT 8.001
DPT 9.0xx
DPT 14.0xx
Channel A
Parameter window A:
Parameter window A:
Channel A
Parameter window A:
Channel A
Parameter window A:
Channel A
Parameter window A:
AA/S 4.1.2, AA/A 2.1.2 | 2CDC505163D0201 57
Data type Flags
Variable C, R, T
DPT variable
General, p. 26, is not
1 bit C, R, T
DPT 1.001
General, p. 26, is set to
General, p. 26, must be set to
1 bit C, R, T
DPT 1.005
General, p. 26, is
1 bit C, R, T
DPT 1.005
General, p. 26, is deactivated.
2 bytes C, R, T
DPT 9.02x
General, p. 26, is deactivated.