Table of Contents
Advertisement
®
ABB i-bus
KNX
Commissioning
3.2.3
Parameter window A: Characteristic
This parameter window is shown if the corresponding function was enabled in
A:
General, p. 26.
Using the function Characteristic you can specify a particular reaction for each output by setting up your
own characteristic. You can enter between 2 and 11 support points for this. Each support point assigns a
specific output value to an input value. The reaction between these values will be linear. Along with the
characteristic you can also prescribe a minimum or maximum output value limit by parameterizing the
minimum and maximum values of the characteristic accordingly.
No of support points
Options:
This parameter enables you to select the number of support points to create the characteristic.
2
3
4
5
6
7
8
9
10
11
Parameter window
AA/S 4.1.2, AA/A 2.1.2 | 2CDC505163D0201 35
Advertisement
Table of Contents
