Chrysler PACIFICA HYBRID 2019 User Manual page 141

NOTE:
• The vehicle is not able to be driven in the
"Ignition or Accessory On" mode, see
"Achieving Vehicle Is Ready To Drive Mode
Using the ENGINE START / STOP Button"
previously defined in this section for further
information.
• The rotary gear selector will turn but only
PARK and NEUTRAL are accessible in the
"Ignition or Accessory On" mode.
4. Push the ENGINE START/STOP button a third
time, without brake pedal being pressed, to re-
turn the ignition to the OFF mode (instrument
cluster will display "OFF").
NOTE:
Only press one pedal at a time while driving the
vehicle. Torque performance of the vehicle could be
reduced if both pedals are pressed at the same time.
If pressure is detected on both pedals simultane-
ously, a warning message will display in the instru-
ment cluster. For further information, refer to "In-
strument Cluster Display" in "Getting To Know Your
Instrument Panel".
AutoPark
AutoPark is a supplemental feature to assist in plac-
ing the vehicle in PARK should the situations on the
following pages occur. It is a back up system and
should not be relied upon as the primary method by
which the driver shifts the vehicle into PARK.
The conditions under which AutoPark will engage
are outlined on the following pages.
WARNING!
• Driver inattention could lead to failure to
place the vehicle in PARK. ALWAYS DO A
VISUAL CHECK that your vehicle is in PARK
by verifying that a solid (not blinking) "P" is
indicated in the instrument cluster display and
near the gear selector. If the "P" indicator is
blinking, your vehicle is not in PARK. As an
added precaution, always apply the parking
brake when exiting the vehicle.
• AutoPark is a supplemental feature. It is not
designed to replace the need to shift your
vehicle into PARK. It is a back up system and
should not be relied upon as the primary
method by which the driver shifts the vehicle
into PARK.
ALWAYS DO A VISUAL CHECK that your ve-
hicle is in PARK by looking for the "P" in the Instru-
ment Cluster Display and on the shifter. As an
added precaution, always apply the parking brake.
If the vehicle is not in PARK and the driver at-
tempts to turn off the engine, if certain condi-
tions are met, the vehicle will AutoPark, auto-
matically shifting the vehicle's transmission to
the PARK position. The rotary shifter will auto-
matically reset itself to the PARK position. The
vehicle's ignition will then move to the OFF po-
sition (Engine OFF). When AutoPark is acti-
vated the instrument cluster will display the mes-
sage "AutoPark Engaged"
AutoPark will engage when all of these conditions
are met:
• Vehicle is equipped with a rotary selector
• Vehicle is not in PARK
• Vehicle Speed is 1.2 MPH (1.9 km/h) or less
• Driver has pushed the ENGINE START/STOP
BUTTON
If the vehicle is not in PARK and the driver exits
the vehicle with the engine running, if certain
conditions are met, the vehicle will AutoPark,
automatically shifting the vehicle's transmission
139