Simple Serial Command At Serial Terminal Program - Wiznet WizFi630 Serial Command Manual

2. Simple serial command at serial terminal program

①
<RF>
This command gets module's firmware version and normally used to check module is
working or not
②
<ATDT>
This command changes module's "serial working mode" as data mode
This is special command so do not type each character and <ATDT> copy and paste it at
terminal program.
③
<+++>
This command changes module's serial working mode as "command mode".
In serial command, Incoming serial data is processed as serial command. In data mode,
Incoming serial data is processed as data and it is sent remote network hosts. This is special
command so do not type each character and <++++> copy and paste it at the terminal
program..
④
<ATDT?>
This command responses module's current serial working mode.
Response "1" : serial server is data mode
Response "0" : serial server is command mode
This is special command so do not type each character and <ATDT?> copy and paste it at
terminal program.
⑤
<WP>
This command set network TCP/UDP port number.
As network server mode, it works as network incoming port number
As network client mode, it is remote host network port number to connect server
Ex) <WP5000>
⑥
<WX>
This command set remote host IP address.
When set, module connect remote host automatically. Ex) <WX192.168.16.11>
⑦
<RQ>
This command responses serial sever's network connection status.
0: Not Connect
1: Connect as client
2: Connected as server
3: Connected as Client/Server
⑧
<WL>
This command saves configured data to flash.
When this command is processed, configed data is kept even if rebooting.
⑨
<abc11>;
This is not command and it is one of sample user data for test
// Set port # as 5000
2