Sony HAP-Z1ES Service Manual page 30

HAP-Z1ES
4-7. WiFi
Procedure:
1. Set the SSID and KEY of the connecting access point with
"SONY_HAP_TEST".
2. Enter the service DIAG mode.
(Refer to "1. Entering Method of The Service DIAG Mode" on
page 25)
3. Rotate the selector knob to select the "7. WiFi".
4. Press the [ENTER] key to enter the "7. WiFi" mode.
7.WiFi
1. Network/Module Info
2. Ping/RSSI
3. Back to Main Menu
4-7-1. Network/Module Info
It can display the wireless network and module information.
Procedure:
1. Enter the "7. WiFi" mode.
(Refer to "4-7. WiFi")
2. Rotate the selector knob to select the "1. Network/module
Info".
3. Press the [ENTER] key to enter the "1. Network/module Info"
mode.
Note: "1. IP Address", "2. Subnet Mask" and "3. Default Gateway" sup-
ports only DHCP.
7-1.Network/Module Info
1. IP Address
2. Subnet Mask
3. Default Gateway
4. SSID
5. KEY
6. Module S/N
7-1.Network/Module Info
3. Default Gateway
4. SSID
5. KEY
6. Module S/N
7. HW ver.
8. Back to WiFi Menu
(Displayed characters/values in the above fi gure are example)
30
172.17.100.27
255.255.0.0
192.168.10.254
SONY_HAP_TEST
SONY_HAP_TEST
201305310100116
172.17.0.200
SONY_HAP_TEST
SONY_HAP_TEST
201305310100116
19
4-7-2. Ping/RSSI
It can display the results indicating whether or not the gateway
responded to the PING and RSSI value.
Note: This mode supports only DHCP.
Procedure:
1. Enter the "7. WiFi" mode.
(Refer to "4-7. WiFi")
2. Rotate the selector knob to select the "1. Network/module
Info".
3. Press the [ENTER] key to enter the "1. Network/module Info"
mode.
4. The results indicating whether or not the gateway responded
to the PING and RSSI value is displayed on the liquid crystal
display.
(When the gateway does not respond to the PING, "Error!!
Can't get gateway-ip" is displayed on the liquid crystal dis-
play)
7-2.Ping/RSSI
Antenna 1
Ping to Gateway (192.168.10.254) OK
RSSI : -70
Antenna 2
Ping to Gateway (192.168.10.254) OK
RSSI : -59
Back to WiFi Menu
(Displayed characters/values in the above fi gure are example)