Congestion Avoidance Configuration Commands; Wred Configuration Commands; Display Qos Wred Interface - H3C S5820X Series Acl And Qos Command Reference

Congestion avoidance configuration
commands
NOTE:
The Layer 3 Ethernet interface in this chapter refers to the Ethernet port that can perform IP routing and
inter-VLAN routing. You can set an Ethernet port as a Layer 3 Ethernet interface by using the port
link-mode route command (see the

display qos wred interface

Syntax
display qos wred interface [ interface-type interface-number ] [ | { begin | exclude | include }
regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256 characters.
Description
Use the display qos wred interface command to display the WRED configuration of an interface.
If no interface is specified, this command displays the WRED configuration of all the interfaces.
Examples
# Display the WRED configuration of GigabitEthernet 1/0/1.
<Sysname> display qos wred interface GigabitEthernet 1/0/1
Interface: GigabitEthernet1/0/1
Current WRED configuration:
Applied WRED table name: queue-table1
Layer 2—LAN Switching Configuration Guide
90
).