Installing The Matrox Morphis Qxt Digital I/O Module - Matrox Morphis QxT Installation And Hardware Reference

Installing the Matrox Morphis QxT Digital I/O
module
To install the Matrox Morphis QxT Digital I/O module, proceed with the
following steps:
1. Make sure that your Matrox Morphis QxT base board is fastened to the computer
chassis.
2. Attach your Matrox Morphis QxT Digital I/O module to the computer chassis.
Anchor the module's bracket to the chassis using the screw that you removed in
the first section.
External digital
I/O connector
3. Connect the Matrox flat ribbon cable, shipped with the module, to the internal
I/O expansion connector of the module. You can connect either end of the cable
to the module; the selected cable connector will latch properly only when the red
wire of the cable is on the top side of the connector.

Installing the Matrox Morphis QxT Digital I/O module

Internal I/O expansion
connector
21