Ipi Electronic System Wiring Diagram - Empire Comfort Systems DVL25FP32 Series Installation Instructions And Owner's Manual

IPI ELECTRONIC SYSTEM WIRING DIAGRAM

If any of the original wire as supplied with this unit must be replaced, it must be replaced with equivalent gauge and temperature
rated wire.
This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently
located, manufactured (mobile) home where not prohibited by local codes. This appliance is not convertible for use with other gases,
unless a certified kit is used.
Do not operate the appliance with panel(s) removed, cracked or broken. Replacement of the panel(s) should be done by a
licensed or qualified service person.
Improper installation, adjustment, alteration, service or maintenance can cause property damage, personal injury or loss of
life. Installation and service must be performed by a qualified installer, service agency or the gas supplier.
30369-18-0619
CAUTION
WARNING
AC/DC Adapter
To install the AC/DC Adapter, connect the round male connector to the
matching connector on the wiring harness (Black/red wires) as shown in the
wiring diagram above. Plug the AC/DC Adapter into the Junction Box Recep-
ticle as pictured with the power cord touching the bottom of the fireplace.
Page 37