Venting Fireplace - Top - Empire Comfort Systems DVL25FP32 Series Installation Instructions And Owner's Manual

vENTING FIREPLACE - TOP (CONT'D)
SEE CHART FOR
PERMISSIBLE
"H" AND "V"
DIMENSIONS
2 FOOT MIN.
VERTICAL PIPE
HARD ELBOW DIMENSIONS
FIREPLACE
SERIES
"A"
49 1/4"
DVL25FP (1,250
mm)
52 1/4"
DVL33FP (1,327
mm)
FLEX PIPE 90 DEGREE BEND
FIREPLACE
SERIES
"A"
49 1/4"
DVL25FP (1,250
mm)
52 1/4"
DVL33FP (1,327
mm)
MINIMUM HOLE LOCATION DIMENSIONS FOR THROUGH
THE WALL HORIZONTAL INSTALLATIONS WITH 90 DEGREE
ELBOW OFF TOP OF FIREPLACE
SEE FIGURE 17 vENTING CHART FOR PERMISSIBLE "H" AND
"v" DIMENSIONS.
Positioning the Fireplace
Determine the exact position of the appliance so the direct vent
termination will be centered (if possible) between two (2) studs. This
will avoid any extra framing. All vent kit pipes should be assembled
on the unit after the unit is secured into the final position.
Cutting the Hole
After the fireplace has been positioned in its permanent location,
the hole through the exterior wall of the house can be cut. This hole
must be 11" (279mm) high x 10" (254mm) wide with its center line
determined by the amount of vertical rise and horizontal run of the
termination. See Figure 21. When locating the hole it must be noted
that the bottom of the cap must be 12" (305mm) above the ground
level, and top of the cap must be no less than 18" (457mm) below
a combustible projection, and no closer than 9" (229mm) to any
wall running parallel to vent termination. See Figures 27 and 28.
NOTE: A minimum 2' vertical rise is required off the top of the
fireplace with all acceptable vent systems.
Page 18
10"
(254mm)
C
11" B
(279mm)
V
H
C
B
A
CENTER OF ELBOW
STRAIGHT OUT
(MINIMUM)
"B" "C"
4 1/2" 6 1/2"
(114 mm) (165 mm) (232 mm)
4 1/2" 6 1/2"
(114 mm) (165mm) (232 mm)
"B" "C"
4 1/2" 6 1/2"
(114 mm) (165 mm) (232 mm)
4 1/2" 6 1/2"
(114 mm) (165 mm) (232 mm)
Figure 21
"D"
9 1/8"
9 1/8"
"D"
9 1/8"
9 1/8"
VENT CAP
9" (229mm) minimum
TO SIDE WALL
Figure 22
Figure 23
30369-18-0619