Table of Contents
Advertisement
Safe operation of these products can only be guaranteed if they are properly installed,
commissioned, used and maintained by qualified personnel (see Section 1.11 on this document)
in compliance with the operating instructions. General installation and safety instructions for
pipeline and plant construction, as well as the proper use of tools and safety equipment must also
be complied with.
1.1 Intended use
Referring to the Installation and Maintenance Instructions, name-plate and Technical Information
Sheet, check that the product is suitable for the intended use/application.
The products listed below comply with the requirements of the Pressure Equipment Directive (PED)
and carry the
The products fall within the following Pressure Equipment Directive categories:
621, 622, 623 and 624
626
921 and 922
923, 925 and 926
i)
The products have been specifically designed for use on steam, air or water/condensate
which are in Group 2 of the above mentioned Pressure Equipment Directive. The products' use
on other fluids may be possible but, if this is contemplated, Spirax Sarco should be contacted
to confirm the suitability of the product for the application being considered.
ii) Check material suitability, pressure and temperature and their maximum and minimum values.
If the maximum operating limits of the product are lower than those of the system in which it
is being fitted, or if malfunction of the product could result in a dangerous overpressure or
overtemperature occurrence, ensure a safety device is included in the system to prevent such
over-limit situations.
iii) Determine the correct installation situation and direction of fluid flow.
iv) Spirax Sarco products are not intended to withstand external stresses that may be induced
by any system to which they are fitted. It is the responsibility of the installer to consider these
stresses and take adequate precautions to minimise them.
v)
Remove protection covers from all connections before installation.
1.2 Access
Ensure safe access and if necessary a safe working platform (suitably guarded) before attempting
to work on the product. Arrange suitable lifting gear if required.
1.3 Lighting
Ensure adequate lighting, particularly where detailed or intricate work is required.
2
1. Safety information
mark when so required.
Product
DN15 - 40
DN50
DN15 - 20
DN25 - 50
Group 2
Group 2
Gases
Liquids
1
SEP
2
SEP
1
SEP
2
SEP
IIM-P067-06 CMGT Issue 4
Hide quick links:
Advertisement
Table of Contents
