Safety Information; Intended Use - Spirax Sarco M10Hi Installation And Maintenance Instructions Manual

Safe operation of this product can only be guaranteed if it is properly installed, commissioned,
used and maintained by qualified personnel (see Section 1.11) in compliance with the operating
instructions. General installation and safety instructions for pipeline and plant construction, as
well as the proper use of tools and safety equipment must also be complied with.

1.1 Intended use

Referring to the Installation and Maintenance Instructions, name-plate and Technical Information
Sheet, check that the product is suitable for the intended use/application.
The product listed below complies with the requirements of the Pressure Equipment Directive
(PED) and carries the
The product falls within the following Pressure Equipment Directive categories:
M10Hi ISO
Peek and Geothermal seats
i) The product has been specifically designed for use on steam, compressed air,water and other
industrial fluids that are in Group 2 of the above mentioned Pressure Equipment Directive.
ii) Check material suitability, pressure and temperature and their maximum and minimum values.
If the maximum operating limits of the product are lower than those of the system in which it
is being fitted, or if malfunction of the product could result in a dangerous overpressure or
overtemperature occurrence, ensure a safety device is included in the system to prevent such
over-limit situations.
iii) Determine the correct installation situation and direction of fluid flow.
iv) Spirax Sarco products are not intended to withstand external stresses that may be induced
by any system to which they are fitted. It is the responsibility of the installer to consider these
stresses and take adequate precautions to minimise them.
v) Remove protection covers from all connections and protective film from all name-plates, where
appropriate, before installation on steam or other high temperature applications.
1.2 Access
Ensure safe access and if necessary a safe working platform (suitably guarded) before attempting
to work on the product. Arrange suitable lifting gear if required.
2

1. Safety information

mark when so required.
Product
DN8
DN10
DN15
DN20
DN25
DN32
DN40
DN50
DN65
Group 1 Group 2
Gases Gases
SEP SEP
SEP SEP
SEP SEP
SEP SEP
SEP SEP
2 SEP
2 1
2 1
2 1
IM-P167-12-EN-ISS1 CMGT
Group 1 Group 2
Liquids Liquids
SEP SEP
SEP SEP
SEP SEP
SEP SEP
SEP SEP
SEP SEP
2 SEP
2 SEP
2 SEP