Nozzle Selection - Hardi COMMANDER Plus Series Operator's Manual

Nozzle Selection

Correct selection of nozzle and calibration of the sprayer are critical to achieve accurate and cost effective use of farm
crop protection products.
®
Your HARDI sprayer has been supplied with 110° flat spray Red ISO Color Tips™ that will apply approximately 20
U.S. GPA at 30 PSI and 5 MPH.
The 110° flat spray nozzle was chosen rather than the 80 degree nozzle for two reasons: 1- It may be used at a lower
minimum height which reduces the risk of wind drift; 2- it's greater overlap permits better uniformity of spray distribution,
particularly if boom height varies on rough ground. Normal boom height setting with 110° nozzles is 18" to 20" above
the crop or weeds, whichever is taller.
Should you wish a different application rate or different type of nozzle, HARDI
need.
IMPORTANT: Always consult your chemical supplier for recommended chemical rate and water
application rate. Always wear protective gloves when handling nozzles.
The following tables show what types of spray nozzles are suitable for different applications. It is important to use the
correct nozzle.
Nozzle Selection
HARDI ® ISO COLOR TIPS™ 110 degree flat fan,one piece
cap and nozzle; color coded for flow rate selection.
For herbicides, insecticides, and fertilizer applications. 50,
80, and 100 mesh screens are normally used.
®
HARDI ISO LowDrift COLOR TIPS™ 110 degree flat
fan,one piece cap and nozzle, 1553 solid stream nozzle;
color coded for flow rate selection.
®
HARDI INJET™ Nozzles; air inclusion nozzles with
removalbe restrictor. Color coded for flow rate selection. In-
Line Filters will normally be used.
FLAT SPRAY NOZZLES in 65 degree, 80 degree, and 110
degree spray angles. For herbicides, insecticides, and
fertilizer applications. 50, 80, and 100 mesh screens are
normally used.
FLOOD NOZZLES set at 40" spacing. Designed for high
volume application.
®
HARDI COMMANDER
® manufactures a nozzle for virtually every
OPERATOR'S MANUAL
F110
LD110
4665-65 degree
2080-80 degree
4110-110 degree
Part # 330013-
O-ring
4598
33