Wiring Diagram - Stuart Turner Monsoon Series Installation, Operation & Maintenance Instructions Manual

The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.

4.21 Wiring Diagram:

M
N
S2 S3 S3 S2
S1
4.22 Fuses: The following fuse size should be used with the appropriate pump.
4.23 Supply Cord Replacement:
The supply cord and internal wiring within the terminal
box are routed and secured to ensure compliance with the
electrical standard EN 60335-1. It is essential that prior to
any disturbance of this internal wiring, all cable routing and
securing details are carefully noted to ensure re-assembly to
the same factory pattern is always maintained.
If the supply cord is to be changed or is damaged, it must be replaced with a
special cord assembly available from Stuart Turner or one of their approved
repairers.
On disassembly note the cord retention and routing system. Re-assemble to the
same pattern.
For information on cable connection consult the wiring diagram and cable gland
fitting instructions.
MAIN WINDING
BLUE
THERMOTRIP
CAPACITOR
START WINDING
N L
S1
FLOWSWITCH
REED (S3)
FLOWSWITCH
REED (S2)
PRESSURE
SWITCH (S1)
Model
U4.0 bar Twin
U4.5 bar Twin
All other models
BLUE
N 230 VAC/1PH/50Hz
BROWN
L
GREEN / YELLOW
E
Fig. 11
Fuse Size (AMPS)
13
5
- 14 -
SUPPLY