Mount The Pump - Graco ChemSafe 515 Instructions - Parts Manual

Mount The Pump

To avoid serious injury from toxic fluid or fumes:
• Ventilate to a remote area. The pump
exhaust air may contain contaminants. See
Air Exhaust Ventilation, page
• Never move or lift a pump under pressure. If
dropped, the fluid section may rupture. Always
follow the Pressure Relief Procedure, page
before moving or lifting the pump.
Accessories/Components Not Supplied
A Air supply line
B Bleed-type master air valve (required
for your pump)
C Air filter/regulator assembly
D
Master air valve (to isolate the
filter/regulator for service)
E Grounded flexible fluid supply line
F Fluid drain valve (required for your
pump)
G Fluid shutoff valve
H
Grounded, flexible fluid outlet line
334794E
11.
14,
1. Be sure the mounting surface can support the
weight of the pump, hoses, and accessories, as
well as the stress caused during operation.
2. For all mountings, be sure the pump is secured
with screws through the mounting feet. Always
mount the pump upright.
3. Make sure the surface is flat and that the pump
doesn't wobble.
4. For ease of operation and service, mount the
pump so air valve, air inlet, fluid inlet and fluid
outlet ports are easily accessible.
System Components
J Air inlet port (not visible)
K Exhaust port and muffler
L Fluid inlet port
M Fluid outlet port
N Mounting feet
Installation
9