C&K systems SYSTEM 238 Installation Manual page 8

SYSTEM 238 Installation Manual
Command Location 00: Installer Combination
Digit Position (1): First Digit of Installer Combination
Hard-coded to "0". Installer's combination will always start with 0.
Digit Positions (2) - (6): Remaining Digits in Combination
Combination must have 5 digits in addition to Position (1).
Valid entries are 0 - 9.
Command Location 01 - 08: User Arming Type and Combination
01 = User #1 (Master)
02 = User #2
03 = User #3
04 = User #4
Digit Position (1): Arming Type
1 = Arm Only, No Closing (C) Report, No Shunting
2 = Disarm Only, No Opening (O) Report, No Shunting
3 = Arm and Disarm, No O/C Reports, No Shunting
4 = Arm Only, with Closing Report, No Shunting
5 = Disarm Only, with Opening Report, No Shunting
6 = Arm and Disarm, with O/C Reports, No Shunting
7 = Arm Only, No Closing Report, Shunting Allowed
8 = Disarm Only, No Opening Report, Shunting Allowed
9 = Arm and Disarm, No O/C Reports, Shunting Allowed
0 = Arm Only, with Closing Report, Shunting Allowed
1 = Disarm Only, with Opening Report, Shunting Allowed
2 = Arm and Disarm, with O/C Reports, Shunting Allowed
Digit Position (2): First Digit of Arming Code
Hard-coded to User's PIN. You cannot change this number.
Digit Positions (3) - (6): Remaining Digits in Combination
Comination may have from 1 - 4 digits in addition to Position (2).
Valid entries are 0 - 9.
NOTE: Some programming locations allow variable-length data and require an
End-of-Number (EON) character. Program
Fill remaining unused Positions with "0". The EON character is not required
if the last digit is in Position (6).
Default Values
**Default Values
05 = User #5
06 = User #6
07 = User #7
08 = User #8 (Guest)
4 ("E") after the last digit.
Command Locations 00 - 08
0 1
0 0
0
(1) (2)
9 1
1
0 1
(1) (2)
PROGRAMMING CONVERSIONS
Hexadecimal Value
A
B
C
D
E
F
8
2 3 4 5
(3) (4) (5) (6)
2 3 4 E
(3) (4) (5) (6)
**Default Values are different for
each user. Refer to the SYSTEM
238 Programming Worksheet at the
end of this manual for other user
default values.
Key Strokes
0
1
2
3
4
5
#
#