C&K systems SYSTEM 238 Installation Manual page 10

SYSTEM 238 Installation Manual
Command Location 0B: Communications Control
Digit Position (1): Delay Before Dial Time
0 = 0 secs 4 = 40 secs
1 = 10 secs 5 = 50 secs
2 = 20 secs 6 = 60 secs
3 = 30 secs 7 = 70 secs
Digit Position (2): Dial Type
1 = DTMF - Touch Tone (10/sec)
Digit Position (3): Enable Keypad Activated RPS
0 = No
1 = Yes; allows remote programming to start from on-site keypad command
Digit Position (4): RPS Enable
0 = No
1 = Yes; allows remote programming to start from off-premise location
Digit Position (5): Phone Ring Type
0 = Single ring; uniformly timed rings with long pauses between rings
1 = Double ring; rings twice quickly followed by a long pause then rings twice again
Digit Position (6): Dialing Attempts
1 = 1 try 5 = 5 tries
2 = 2 tries 6 = 6 tries
3 = 3 tries 7 = 7 tries
4 = 4 tries 8 = 8 tries
Command Location 0C: Account Number 1
Digit Positions (1) - (6): Account Number
Valid entries are 0 - F.
The Account Number is right justified. The last digit must be in Position (6).
The SYSTEM 238 will read the account number using:
Digit Positions (4) - (6) in 3-digit accounts
Digit Positions (3) - (6) in 4-digit accounts
Digit Positions (1) - (6) in 6-digit accounts
Fill all unused Digit Positions with 0's.
Default Values
2 = 120 secs
8 = 80 secs
3 = 130 secs
9 = 90 secs
0 = 100 secs 4 = 140 secs
1 = 110 secs 5 = 150 secs
2 = DTMF (5/sec)
3 = 13 tries
9 = 9 tries
0 = 10 tries 4 = 14 tries
1 = 11 tries 5 = 15 tries
2 = 12 tries
Default Values
Command Locations 0B and 0C
0
0 B
(1)
3 = Pulse (10/sec)
0
0 C
(1)
Hexadecimal Value
10
3 1 1 0
(2) (3) (4) (5)
0 0 0 0
(2) (3) (4) (5)
PROGRAMMING CONVERSIONS
Key Strokes
A
B
C
D
E
F
8
#
(6)
0
#
(6)
0
1
2
3
4
5