C&K systems SYSTEM 238 Installation Manual page 18

SYSTEM 238 Installation Manual
Command Location 2E: Audible/Visual Switches
Default Values
Digit Position (1): Entry Pre-alarm Enable
0 = No
1 = Yes: sounds keypad buzzers during entry delay
Digit Position (2): Exit Pre-alarm Enable
0 = No
1 = Yes: sounds keypad buzzers during exit delay
Digit Position (3): Bell Reverse Operation
0 = No
1 = Yes: supplies bell voltage in non-alarm state; Bell requires external power supply
Digit Position (4): Ring Back
0 = No
1 = Yes: Automatic Bell test after arming (and Exit Delay has expired) for local or non-supervised
accounts; follows closing report for supervised accounts; sounds bell for 2 seconds.
Digit Position (5): Disable Loop LEDs
0 = No
1 = Yes: turns off keypad zone LEDs after 5 minutes
Command Location 2F: Unit Control
Default Values
Digit Position (1): Local System Only
0 = No
1 = Yes: disables all communications except RPS
Digit Position (2): Enable Daily Dynamic Battery Test
0 = No
1 = Yes: tests battery under load every 24 hours
Digit Position (3): Enable Four Minute Power-Up Delay
0 = No
1 = Yes: suppress alarms on power-up for 4 minutes
Digit Position (4): Enable Soft Zone Operation
0 = No
1 = Yes: allows use of Emergency, Fire, and Police keys
Command Locations 2E and 2F
1 1
2 E
(1) (2)
1 0
2 F
(1) (2)
18
0 0 0
#
(3) (4) (5)
0 1
#
(3) (4)