C&K systems SYSTEM 238 Installation Manual page 15

Command Locations 27 - 29
Command Location 27: Soft Zone A (EMERGENCY)
Default Values
This Zone is identified by the "E" key
on the Alpha II and LED keypads.
Digit Positions (1) and (2): Emergency Zone Code Report
Only Position (1) is sent for 3/1 and 4/1 formats.
Positions (1) and (2) are sent for 3/1 Extended, 4/2, and CFSK formats.
Program 00 to disable alarm reporting for Emergency zone.
Digit Position (3): Emergency Zone Receiver Select
0 = Receiver 1 with Receiver 2 as back-up
1 = Receiver 1 only
Digit Position (4): Emergency Zone Loop Bell Type
1 = Pulsing 2 = Steady
Command Location 28: Soft Zone B (Fire)
Default Values
This Zone is identified by the "F" key
on the Alpha II and LED keypads.
Digit Positions (1) and (2): Fire Zone Report Code
Digit Position (3): Fire Zone Receiver Select
Digit Position (4): Fire Zone Loop Bell Type
Command Location 29: Soft Zone C (Police)
Default Values
This Zone is identified by the "P" key
on the Alpha II and LED keypads.
Digit Positions (1) and (2): Police Report Code
Digit Position (3): Police Zone Receiver Select
Digit Position (4): Police Loop Bell Type
2 = Receiver 2 only
3 = Receiver 1 and Receiver 2 (Dual Reporting)
3 = Chirp 4 = Silent
0
2 7
(1)
NOTE: Command Location 2F Digit Position (4)
0
2 8
(1)
0
2 9
(1)
PROGRAMMING CONVERSIONS
Hexadecimal Value
A
B
C
D
E
F
15
SYSTEM 238 Installation Manual
0 1 3
#
(2) (3) (4)
must be programmed to YES to enable
Soft Zones.
0 1 1
#
(2) (3) (4)
Refer to CL 27 for information about
programming this zone.
0 1 2
#
(2) (3) (4)
Refer to CL 27 for information about
programming this zone.
Key Strokes
0
1
2
3
4
5