“Ele.h” Button; “Anti-Fungus” Button; “Spot Swing” Button; “Eco” Button - Tadiran Telecom Swift Inverter 9U Service Manual

* The clean function will be stop working after about 30 minutes running working
without any operation.
12."ELE.H" button(only for hot pump type)
* In heating mode, press this button, the mode of operation is shifted into
supplementary electric heating.
13."Anti-FUNGUS" button
* The purpose of this function is to dry the inside of the evaporator and to prevent the
evaporator from going mouldy due to water deposition and thus dispersing strange
smell.
* This function is controlled by the remote controller under cooling, dry and auto
(cooling and dry) modes, the horizontal wind guiding bars are at the initial position
for cooling. The A/C runs under heating mode(the cooling only A/C only runs under
fan mode), the internal fan runs for 3 minutes with weak wind before stop.
* This function has not been set in the factory. You may freely set and cancel this
function. The setting method is: under "off" status of the A/C and the remote
controller, point the remote controller toward the A/C and continuously press
"Anti-FUNGUS" button for one time, the buzzer keep beeping five times again after
five times beep, indicating that this function is ready. In case this function has been
set, unless the whole A/C is powered off or the function is manually cancelled, the
A/C then has this function as default.
* To cancel the function: 1. Under "off" status of the A/C and the remote controller,
point the remote controller toward the A/C and continuously press
"Anti-FUNGUS"button for one time, the buzzer keep beeping three times again after
five times beep, indicating that this function has been cancelled; 2. Power off the
whole A/C.
* When this function is on, it is suggested not to restart the A/C before it is
completely stop.
* This function will not run in case of time stop.
14."SPOT SWING" button
* Press this button, the horizontal wind direction vanes can swing automatically, when
you have the desired vertical wind direction.
* Press it again, the horizontal wind direction vanes will be stopped at the situation of
your choice.
15."ECO" button
* In cooling mode, press this button, the unit will runs "ECO" economic operation
mode which costs the least power consumption.
* After running for 8h, it will automatically exit, otherwise, press this button once
again to quit it.
* Note: The unit will turn off automatically if the timing mode are running out of
time.
2) Introduction for mode settings
18