Swing; Anti-F; Introduction For Mode Settings; Automatic Operation Mode - Tadiran Telecom Swift Inverter 9U Service Manual

* Press this button to enter SLEEP mode, which the unit will exit after 10 hours of
continuous operation and restore to the previous status.
Note: The SLEEP function cannot be activated in FAN mode.

12. SWING

* Press this button to activate up/down swing and press it again to fix the swing
position.
13. SWING
* Press this button to activate left/right swing and press it again to fix the swing
position.

14. Anti-F

* The Anti-F functions when the unit is turned off with the remote controller in COOL,
DRY or AUTO mode. It will operate in HEAT mode (FAN mode for cool only units),
with the internal fan running with weak flow for 3 minute before stop, to remove the
moisture within the evaporator so as to prevent it from giving bad smell from mold.
* This function is not set in the factory. You may set it or cancel it any time you want
as follows: With both the unit and the remote controller OFF, point the remote
controller at the unit and press
"Anti-F" button once, the buzzer will sound 5 times after 5 times, indicating this
function is set. Once set, this function will remain valid except when the unit is power
off or until it is canceled.
* To cancel Anti-F:
1. Power off the unit.
2. With both the unit and the remote controller OFF, point the remote controller at the
unit and press this button once, the buzzer will sound 3 times after 5 times, indicating
this function is canceled.
Note:
* With Anti-F activated, it is advised not to turn ON the unit again before it is fully
OFF.
*Anti-F function will be invalid when OFF timer is set.
15.This button has two functions.
a. ELE.H (Optional)
* If this button is pressed in HEAT mode, the electric heating will be turned on/off.
b. ECO (Optional)
* If this button is pressed in COOL mode, the unit will enter the ECO mode which has
the lowest electricity consumption, and exit it automatically 8 hours after.
* Changing modes or turning off the remote controller will automatically cancel the
ECO function.
* Press ECO button in ECO mode to exit this mode. Note: The ECO mode only works
for inverter units.

2) Introduction for mode settings

★Automatic operation mode

1. Press the "MODE" button, select the automatic operation mode.
2. By pressing the "SPEED" button, you can select the fan speed from LOW, MID,
HIGH, AUTO.
3. Press the "ON/OFF" button, the air-conditioner starts to operate.
4. Press the "ON/OFF" button again, the air-conditioner stops.
Note: In the fan operation mode the temperature settings is non-effective.
★Cooling/Heating operation mode
12