Tadiran Telecom Swift Inverter 9U Service Manual page 72

1) Take all the connector of
PCB upper side out.(Including
Power cord)
Electrical
2) Detach the outdoor unit
Parts
connection
(Main PCB)
terminal block.
3) If pulling the main PCB up,
it will be taken out.
Remove axial sleeve of louver
air vent, link, bend the air vent outwards
louver link and then remove the air vent
and louver link.
Pipeline
Remove the Pipeline clamp.
clamp
Mounting
Remove the Mounting plate.
plate
1) Loosen fixing earth screws
of right side.
2) Detach the connection pipe.
3) Detach the holder pipe at the
Heat
rear side.
Exchanger
4) Loosen fixing screws of
right and left side.
5) Detach the heat exchanger
from the indoor unit.
wire from the
71