Requirements
You must have the following:
AZedit v3.9.0 or later
•
Master Controller v2.2.0 or later
•
MADI 16 Plus v2.0.0 or later
•
If using a multi frame system, with DBX:
•
DBX v1.23.0 or later
PeriphII-e v 1.23.0 or later
How to Install
Use the following instructions for your initial setup of a MADI 16 Plus Card.
CAUTION: If you do not follow these instructions, the MADI card may not work properly.
Card Installation
To install the MADI 16 Plus front and back card, do the following:
Gently insert the MADI 16 Plus front card into the front of the ADAM frame.
1.
Tighten the MADI 16 Plus front card.
2.
CAUTION:Do not fully tighten the front card into the frame.
From the back of the ADAM frame, insert the back card, aligning it with the front card.
3.
Ensure the back card is properly seated against the MADI 16 Plus front card and is sitting firmly in the frame.
4.
Tighten the back card to the frame.
5.
Fully tighten the MADI 16 Plus front card.
6.
IMPORTANT: If you remove the MADI 16 Plus back card after installing it, and then replace it. You must reboot
the MADI 16 Plus front card.
CHAPTER 2
Installation
15