Active Link Display Column
The Active Link display column shows the status of the active link (Fiber A, Fiber B, or Coax).
There are two (2) status message possibilities: OK and Bad
Backup Link Display Column
The Backup Link display column shows the status of the backup link, if configured. This column is blank if the card is not
configured for redundant fiber, link mode set to Fiber A+B. See "Link Mode Drop Down Column" on page 19.
NOTE:
The backup link can never be Coax.
There are two (2) status message possibilities: OK and Bad
Status Display Column
The Status display column shows status of the MADI card in the slot.
There are four (4) status message possibilities:
OK
Wrong Back Card -
The wrong back card is installed.
FPGA Boot Failure -
PLL Unlocked -
Pass-Through Display Column
The Pass-Through display column shows type pass-through connection being used.
Available selections for this field are: RS-232 and RS-485
MADI to Serial Display Column
The MADI to Serial display column shows the number of bytes received on the MADI link and transmitted out on the serial
connection.
Serial to MADI Display Column
The Serial to MADI display column shows the number of bytes received on the Serial connection and transmitted out on the
MADI link.
MADI Card Status Window
23