Table of Contents
Advertisement
Sample Rate Drop Down Column
The Sample Rate drop down column is used to select the speed the MADI card references for transmission.
IMPORTANT:
When Word Clock is selected as the type of clock, the sample rate must match the Word Clock driver.
•
When Internal or NTSC/PAL is selected as the type of clock, the sample rate must match the device at
•
the other end of the connection.
Available selections for this field are: 44.1KHz and 48.0KHz
# of Channels Drop Down Column
The # of Channels drop down column is used to select the number of channels on the MADI card. The MADI card can have
up to 64 channels assigned to each card.
Available selections for this field are: 56 and 64
Link Mode Drop Down Column
The Link Mode drop down column is used to select the connector you want use. For connector locations, see Figure 1 on
page 5.
NOTE:
Redundancy is only supported between singular point-to-point connections.
Available selections for this field are:
Fiber A -
Fiber B -
Fiber A and B -
Coax -
Baud Rate Drop Down Column
The Baud Rate drop down column is used to select the baud rate for the serial port.
Available selections for this field are:
None
9600bps
19.2Kbps
38.4Kbps
Show MADI Cards Only Check Box
The Show MADI Cards Only check box indicates only MADI cards are displayed in the window.
The signal is sent over the Fiber A connection.
The signal is sent over the Fiber B connection.
The signal is sent over the Fiber A connection, however, if Fiber A fails or is
damaged, the Fiber B connection takes over sending the MADI stream.
The signal is sent over the coaxial connection.
MADI Card Configuration Window
19
Advertisement
Table of Contents
