Setting The Transmission Format; Recording Memo - Sony SIR-3400H Instruction Manual

12. Operation Settings (Using Setting key)

12-8. Setting the Transmission Format

Set the S/D select switch on the front of measuring unit to the desired format.
1
When using the IEPE input, set to S. When set to D, the unit does not work.
Setting Transmission format
S Single ended input
D Differential input
When using in the differential input, connect the signal source to the measuring unit as shown below.
Unless the signal source is connected with the frame ground of measuring unit, signal may not be
properly recorded.
Signal source
Signal hot – BNC terminal (Core of coaxial cable)
Signal cold – BNC GND (Shield wire of coaxial cable)
Ground terminal – Ground terminal (Frame ground connection)

12-9. Recording Memo

Up to 96 characters of information can be set during recording.
1
Press the MEMO key.
The lamp at the top left of the key turns on, and the Record Memo indicator appears in the setting value
display area to indicate that the memo can be edited.
12-8
(E)
Supported input format
Direct input, IEPE input
Direct input
Measuring unit
(Modes: STOP, E-E, REC-PAUSE, and REC)
SIR-3400H / SIR-3032i / SIR-3032W