Setting And Check Items; Default Settings; Recording Unit Setting/Checking (Including Media Settings) - Sony SIR-3400H Instruction Manual

6. Setting and Check Items

6-1. Default Settings

c
Items described here as check items can only be checked.

6-1-1. Recording Unit Setting/Checking (Including Media Settings)

O: Setting enabled The reference section for common Telnet functions is section 17-2, and so this reference was omitted except for independent functions.
Setting
Fan control
Condensation sensor
Synchronization mode
Frequency type
Auto repeat
Overwrite
Trigger mode
Pre-trigger recording
IRIG-B timecode
Response characteristics
of the peak indicator
Bar meter scale
LCD contrast
LCD brightness
Recording unit network
Setting the recording unit clock
ID number
INDEX number
Recording/Playback speed
Number of recording channels
Transmission format
Recording memo
Test signal
Mark
Changing to the address,
amount of recording media
remaining, or time display
Clearing the peak
indicator and over indicator
Changing the speaker
output
Adjusting the playback volume
Changing the AC voltage
Save of setting values/
Recall of setting values
SIR-3400H / SIR-3032i / SIR-3032W
Default setting Operation
LCD screen Key
Off O
Off O
Master O
48 kHz series O
Off O
Off O
Single O
Off O
On O
Realtime O
% O
5 O
O
5
— O
O
—
—
—
1 (Normal)
32 ch
S (Single-ended)
—
—
—
— O
On O
Voice
annotations
—
100/120 V or
200/240 V
O
—
Remarks
Telnet Panel
For acoustic measurement and other
situations where silence is needed
Based on changes in the operating environment 7-2-2
Based on changes in the operating environment 7-2-3
Fixed at 48 kHz series
O For setting at hard disk empty states
O For starting recording with an external signal
For recording signals before the trigger
For using IRIG input
O
O For switching the bar meter indicator
For adjusting the screen
For adjusting the screen
O
Before recording
O O For adding IDs during recording
O
For adding INDEX during recording
O O For changing the speed
O
O (Front) For the IEPE input, set to the single
ended input.
O O
If needed during recording
O O For recording test signals
O O
If needed during recording
O
O
When the speaker or earphone playback 13-3
signal source is switched
O (Front) Based on the operating environment
O (Rear)
For making batch settings with the default
settings or with recording settings with a
current address
Reference
section
7-2-1
8-2-1
8-2-2
8-2-3
8-2-4
8-2-5
8-2-6
9-2-1
9-2-2
9-2-3
9-2-4
10-1
11-1
12-1
12-2
12-3
12-4
12-8
12-9
12-11
12-12
13-1
13-2
13-4
13-5
14-1
6-1
(E)