Connecting The Aux Digital Data; Recording Aux Digital Data Signals; Playback Aux Digital Data Signals - Sony SIR-3400H Instruction Manual

15. Data Recording/Playback

15-4-1. Connecting the AUX Digital Data

Use a BNC cable (sold separately) to connect the AUX-1 (DIGITAL) IN connector on the rear panel and the
signal source.
If necessary, use a BNC cable to connect monitoring equipment to the AUX-1 (DIGITAL) OUT connector
on the rear panel.
When AUX digital data is input (high and low occur repeatedly within a set interval) in the E-E, REC-
PAUSE or REC mode, the input state is displayed in the status display area of the LCD screen. If it is not
displayed, check the cable connections.
Signal source
Monitoring equipment
c
. Do not input simultaneously a signal with a different ground level than those of the analog data signals.
. The input/output level is TTL.

15-4-2. Recording AUX Digital Data Signals

When recording starts, the AUX digital data signal input to the AUX digital channel is recorded on the
recording media simultaneously along the main data signals.
Also, when an input signal is detected, the input state is displayed in the status display area of the LCD
screen.

15-4-3. Playback AUX Digital Data Signals

When playing back a recording media on which an AUX digital data signal has been recorded, the AUX
digital data signal is output from the AUX-1 (DIGITAL) OUT connector on the rear panel.
Also, when a playback signal is detected, existence of the input signal during recording is displayed in the
status display area of the LCD screen.
15-7
SIR-3400H / SIR-3032i / SIR-3032W
(E)