MEDIATEK LinkIt Smart 7688 Developer's Manual page 49

4.6.5. Connecting LinkIt Smart 7688 to a Wi-Fi Access Point To Access
Internet
This section describes how LinkIt Smart 7688 development board connects to an AP in a Wi-Fi
network to access the Internet. To connect to an access point, LinkIt Smart 7688 needs to be in
Station mode. For more information please see section3.5, "Network Environment".
4.6.5.1. Using the Web UI
Open a browser with URL mylinkit.local. Please see section 4.5.3, "Connecting to the
Web UI" if you've not signed in before.
Click Network button on upper right as shown in Figure 29.
1)
Select the Station mode and click Refresh or downward arrow on the right to find the AP
2)
to connect to. After you've selected the AP, enter password if required. Click Configure &
Restart to finish as shown in Figure 30.
Note: If you entered the AP's password incorrectly, you can reset the board to AP mode by clicking the
Wi-Fi button for at least 5 seconds and restart network setting to Station mode again.
This document contains information that is proprietary to MediaTek Inc.
Unauthorized reproduction or disclosure of this information in whole or in part is strictly prohibited.
MediaTek LinkIt™ Smart 7688 Developer's Guide
Figure 29 Change networking setting in Web UI
© 2015, 2016 MediaTek Inc.
Page 49