GE Dash 3000 Service Manual page 152

Select Procedures
6-4
Configuration: Configuring a Monitor
Choose and program the monitor settings listed below in the order
presented. Each procedure is described on the next pages.
NOTE
Country approval of the AFIB Identification software feature is
currently pending in Japan.
Main Menu Selections
Set Unit Name
Set Bed Number
Patient-Monitor Type
Set Graph Locations
Admit Menu
Boot Code Selections
Defib Sync Voltage
Defib Sync Pulse Width
Line Frequency
CIC Protocol
QS Protocol
MUSE Protocol
Transcutaneous Pace Blank Length
Country Selection
Configure Wireless LAN
Set Language
AFIB Identification
IntelliRate
Analog Out Buzz
After completing all necessary procedures, perform the "Checkout
Procedure" found in Chapter 4, Maintenance.
Dash 3000/4000 Patient Monitor
2000966-339
Revision A