Micropilot FMR51, FMR52
Customized parametrization
Tagging (TAG)
Services
13)
Feature 570 of the product structure
Endress+Hauser
If the option IJ "Customized parametrization HART", IK "Customized parametrization PA" or IL
"Customized parametrization FF" has been selected in feature 570 "Service", customer specific
presettings can be selected for the following parameters:
Parameter
Setup → Distance unit
Setup → Empty calibration
Setup → Full calibration
Setup → Adv. Setup → Current output 1/2 → Damping
Setup → Adv. Setup → Current output 1/2 → Failure mode HART
Setup → Adv. Setup → Current output 1/2 → Burst mode
Ordering feature
Option
Position of the measuring
point marking
Definition of the measuring
point designation
Designation in the Electronic
Name Plate (ENP)
Designation on the display
module
The following services can be selected via the product structure in the Product Configurator
• PWIS free (PWIS: paint wetting impairment substances)
• Customized parametrization HART → 99
• Customized parametrization PA→ 99
• Customized parametrization FF → 99
• Without tooling DVD (FieldCare)
Communication
• HART
• PA
• FF
• HART
• PA
• FF
• HART
• PA
• FF
HART
HART
895: Marking
Z1: Tagging (TAG), see additional spec.
To be selected in the additional specifications:
• Tag plate Stainless Steel
• Self-adhesive paper label
• Supplied label/plate
• RFID TAG
• RFID TAG + Tag plate Stainless Steel
• RFID TAG + Self-adhesive paper label
• RFID TAG + Supplied label/plate
To be defined in the additional specifications:
3 lines containing up to 18 characters each
The measuring point designation appears on the selected label and/or the
RFID TAG.
The first 32 characters of the measuring point designation
The first 12 characters of the measuring point designation
Selection list / range of
values
• in
• ft
• mm
• m
max. 70 m (230 ft)
max. < 70 m (230 ft)
0 to 999.9 s
• Min
• Max
• Last valid value
• Off
• On
13)
:
99
Need help?
Do you have a question about the Micropilot FMR51 and is the answer not in the manual?