Keypad (Cancode) (O) - Jungheinrich ESE 220 Operating Instructions Manual

7.4

Keypad (CanCode) (o)

7.4.1 Code lock
The code lock allows a user or group of users to assign an individual user code.
Travel programs can also be assigned to the individual user codes. The user code is
configured with a master code and is described in the following sections in this
chapter.
When you have entered the valid user code the truck will be operational. The truck
will be able to perform travel, steering and hydraulic operations.
When you have entered the valid master code the truck will be switched on. Travel
operations are inhibited. The truck will be able to perform steering and hydraulic
operations. The code lock is in programming mode. When you enter one of the
following parameters the settings in the code lock can be changed.
Parameter
0-0-0
0-0-1
0-0-2
0-0-3
0-0-4
0-1-0
0-2-4
In the as-supplied condition, the code is indicated on a sticker. When using the truck
for the first time, change the master and user codes and remove the sticker.
– Default user code: 2-5-8-0
– Default master code: 7-2-9-5
Z
When allocating the codes, ensure the rider trucks are given a different code than
pedestrian trucks.
84
–
–
–
–
–
– Switch on the truck automatically
– Assign travel programs to the user codes
Description
Change master code
(see page 87)
Add user codes
(see page 89)
Change a user code
(see page 91)
Delete a user code
(see page 93)
Delete all user codes
(see page 95)
(see page 97)
(see page 99)