Adjustment Of Heating Setpoint; Enable/Disable The Heating Function; Adjustment Of Domestic Setpoint; Enable/Disable The Domestic Function - Riello INSIEME EVOe 32 B/110 LN User Manual

Once the initialization phase is complete, the display switches to
"basic display" mode.
In this mode, the main information on the equipment opera-
tion is displayed. The meaning of the different icons displayed
is explained in paragraph "Control panel". The icon
heating delivery temperature are displayed, either if the boiler
is in stand-by mode or if a temperature request is active (icon
blinking).
To switch off the equipment, set the main switch to "0".
9
Never power off the appliance before switching the master
switch to the "0" position.
9
Never switch off the appliance with the master switch if a
request is active. Always make sure that the appliance is in
stand-by before switching the main switch.
Example of generator stand-by display in heating only mode
(external probe not connected)
Bar
− Set the room thermostat to the required temperature (~
20°C) or, if the system has a timer or timer-thermostat,
make sure that this is switched "ON" and adjusted to the
required temperature (~ 20°C).;
2.1.3

Adjustment of heating setpoint

− Press the key"+" or "-" to display the current value of the
heating temperature setpoint.
− Increase or decrease the setpoint according to the type of
system by using the key "+" of "-".
− To save the modification made and go back to the initial
screen, wait for 3 seconds or press the key "ENTER/RESET".
− Check that the thermal unit starts the ignition phase and
that the display shows the icon
heating request) and the icon
− The boiler now starts up and the burner remains lit until
the temperature setpoint is reached.
2.1.4

Enable/disable the heating function

− Press the keys "+" and "-" simultaneously for a few sec-
onds;
− The icon
blink on the display;
and the
− Press the keys "+" and "–" to select the required mode;
− Press the key "ENTER/RESET" or wait for 3 seconds to save
the modification made and go back to the initial screen.
2.1.5

Adjustment of domestic setpoint

− Press the key "▲" o "▼" to display the current value of
°C domestic setpoint.
− Increase or decrease the setpoint by using the key "▲"
o "▼".
− To save the modification made and go back to the initial
screen, press the key "ENTER/RESET".
2.1.6

Enable/disable the domestic function

− Press the keys "▲" and "▼" simultaneously for a few
seconds;
− The icon
will blink on the display;
°C
− Press the keys "▲" and "▼" to select the required mode;
− To save the modification made and go back to the initial
screen, press the key "ENTER/RESET".
15
blinking (ambient
.
and the current heating mode (ON or OFF) will
and the current domestic mode (ON or OFF)
USE
°C