Daikin RoCon HP Operating Instructions Manual page 10

Hide thumbs Also See for RoCon HP:
Table of Contents

Advertisement

3
x
Operation
Short
Explanation of the displayed value
designation
TVBH2 = TVBH
TR2
Current heating return flow temperature, sec-
ondary sensor (t
Tdhw2 Current temperature in domestic hot water
storage tank, secondary sensor (t
Tliq2
Current coolant temperature (t
TA2
Actual outdoor temperature (measured by tem-
perature sensor of the external heat pump)
quiet
Shows the status of the whisper mode
Tab. 3-5 Description of the operating data displayed as an overview
Fig. 3-5
Display operating data overview
Operating instructions
10
)
R2
)
DHW2
)
L2
Info
Overview
Water Pressure
Off
Displaying the water pressure
On the Control RoCon HP, when it is switched on, you can
display the system pressure (water pressure) in the internal
circuit (direct heating circuit). The water pressure is available as
the first info parameter (see fig. 3-6).
The permissible range of water pressure during operation de-
pends on the Daikin Altherma EHS(X/H) and the heating system.
The set values and threshold values must only be changed by the
heating technician. If the water pressure falls below the minimum
value (set parameter value), it must be increased by topping up
the system (see installation instructions of the Daikin Altherma
EHS(X/H)).
The pressure limits for the safety switch-off and the set
pressure can be adjusted in the parameter settings in
level "System Configuration".
Fig. 3-6
Info values display (e.g. system pressure)
Info
Overview
Water Pressure
T-HS
Water Pressure
Daikin RoCon HP
Daikin Control
008.1420844 – 05/2014

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ehs157034Ehs157068

Table of Contents