Fuses - Emerson Fisher FLOBOSS 407 Instruction Manual

FloBoss 407 Instruction Manual
The cold hard start reloads all restart configuration data from program-
mable ROM (flash memory). Generally, a Cold Hard Start should not be
used on a FloBoss that is actively gathering data and performing control.
Save or document all data and parameter values that could be affected
before performing the cold hard start. Refer to Section 2.5.2, Backup
Procedure Before Removing Power on page 2-21.
The following list shows the values that are saved to memory and restored after a Cold Hard Start.
♦ Device Address and Group.
♦ Station name.
♦ Number of history points in each module.
♦ Contract hour.
♦ User program enable flags – COM1, COM2, and USER/CALC
♦ All communication port settings, including power control settings.
♦ History point configuration.
♦ Discrete input parameters.
♦ Discrete output parameters.
♦ Analog input parameters.
♦ Analog output parameters.
♦ Pulse input parameters.
♦ AGA parameters.
♦ PID parameters.
♦ Configurable Opcode parameters.
♦ AI Calibration.
♦ FST tags.
♦ FST registers.
♦ FST run flag is cleared.
♦ FST instruction pointer is reset to the first instruction.
♦ Softpoints tags are set to their default values and all registers are set to zero.

2.5.6 Fuses

The FloBoss 407 uses the overload protection devices listed in Table 2-4. The overload protection
devices are not field replaceable.
2-24
CAUTION
Rev 5/00