Table of Contents
Advertisement
GUZZLER CLEAN UP
1.) Drain the tank — locate discharge valve at the front of tank. Position for proper draining. Lift "T"
handle to regulate solution discharge. Tip machine forward for complete drainage. Take care not
to damage squeegee when draining.
2.) Rinse the tank with water.
3.) Remove hose from the top of the pump to drain solution that is past the pump.
4.) To tilt machine, rest the unit on the foot bar and handle. This will expose the undercarriage for
cleaning.
5.) Rinse wheels, chassis, and squeegee.
6.) Drain pump by gently pressing on the inlet flapper valve located in the center of the pump plate.
7.) Flushing pump: hold a hose next to the inlet flapper valve while simultaneously activating the
pump by turning a drive wheel. Be sure to drain excess solution from pump.
8.) Re-install hose to pump.
TRANSPORTING THE GUZZLER
The Guzzler should be transported with the front swivel caster on the ground. The chassis should be in
the "up" or transport position. When moving from site to site, DO NOT drag squeegee across parking
lots or thresholds.
STORING THE GUZZLER
It is very important to drain all liquid from the unit if it is to be stored or transported in freezing conditions.
12-2018
Solution will discharge in a large steady stream with some pressure. Wear
protective eye wear and avoid skin contact with all chemicals used in this
tank.
Failure to clean the Guzzler as directed will void the Warranty.
Please responsibly dispose of dirty water and used chemicals.
Never lift tank by gripping the lid retainer ring.
GUZZLER OWNER'S MANUAL PAGE 6
Advertisement
Table of Contents
