Main Frame, Base And Others - Makita LW1400 Technical Information

5-3-6 Main frame, Base and others

5-3-6-1 Disassembling
Push down the motor section, and then hold the main body as follows:
1)
· (LW1400) with Stopper pin (115)
· (LW1401) with chain (64) on Handle set (23, 30)
Stopper pin (115)
LW1400
Set Eye wrench 10 to M6 Hex nut (118) and remove
3)
M6x12 Hex socket bolt (116) using Hex wrench 5.
Hold Gear housing complete firmly and then release
4)
Stopper pin (115) or Chain (64) slowly to move up Gear
housing complete.
Hex wrench 5
M6x12 Hex
socket bolt (116)
Lay the main frame on its side so that Safety cover
6)
comes to the bottom.
Fig. 6-1
Fig. 6-3
M6 Hex nut
(118)
Eye wrench 10
Fig. 6-5
Safety cover (17)
Chain (64)
LW1401
Remove M10x140 Hex bolt (85) and M10-17 Hex nut
5)
(74) with Wrench 17 and Socket bit 17 and Cordless
impact driver.
Note: Before assembling, apply Makita grease FA No.2 a
little in the position shown by the yellow arrow.
Wrench 17
Pull out Pipe 20-128 (77) while rotating with 1R003.
The plier can hold the inside of Pipe.
Note: Before assembling, apply Makita grease FA No.2
a little in the position shown by the yellow arrow.
1R003
Pipe 20-128 (77)
Makita Corporation
Fig. 6-2
Remove M6x12 PH screw (82) for fixing
2)
Spark guard (81). Then remove Spark
cover (99) by unscrewing two M4x6
PH screws (98).
Spark cover
(99)
Base (86)
Fig. 6-4
Fig. 6-6
ﾊﾟｲﾌﾟ 20-128
Spark guard (81)
Socket
bit 17
11 / 15