Supplemental Flight Data; Timer/References Window - Garmin G1000 Pilot's Manual

FLIGHT INSTRUMENTS

2.3 SUPPLEMENTAL FLIGHT DATA

Pressing the DFLTS Softkey (a second-level PFD softkey) turns off metric Altimeter display, the Inset
NOTE:
Map, and wind data.
Some displayed information disappears when pitch exceeds +30˚/-20˚ or bank exceeds 65˚. The Altimeter and
Airspeed, Attitude, Vertical Speed, and Horizontal Situation indicators remain on the display and the Bearing
Information and Annunciation windows can be displayed during such situations. The following information
is removed from the PFD (and corresponding softkeys are disabled) when the aircraft experiences unusual
attitudes:
• Traffic Annunciations
• AFCS Annunciations
• Flight director Command Bars
• Inset Map
• Outside Air Temperature (OAT)
• DME Information Window
• Wind data
• Selected Heading Box
• Selected Course Box
• Transponder Status Box

TIMER/REFERENCES WINDOW

The Timer/References Window is enabled/disabled in the lower right corner of the PFD by pressing the TMR/
REF Softkey. This window provides access to the following settings:
• Generic timer
• Vspeed values and flags (see Airspeed Indicator discussion)
• Barometric minimum descent altitude (MDA, also decision height, DH; see Section 2.4)
2-20
• System Time
• PFD Setup Menu
• Windows displayed in the lower
right corner of the PFD:
– Timer/References
– Nearest Airports
– Flight Plan
– Alerts
– Procedures
– ADF/DME Tuning
Figure 2-29 Timer/References Window
Garmin G1000 Pilot's Guide for Cessna Nav III
• Barometric Minimum Descent
Altitude Window
• Glideslope, Glidepath, and
Vertical Deviation indicators
• Altimeter Barometric Setting
• Selected Altitude
• VNAV Target Altitude
190-00498-01 Rev. A