Garmin G1000 Pilot's Manual page 420

APPENDIX A
GIA 63 MESSAGE ADVISORIES (CONT.)
Message
ABORT APR – Loss of GPS navigation.
Abort approach.
TRUE APR – True north approach. All
angles are TRUE.
GPS1 FAIL – GPS1 is inoperative.
GPS2 FAIL – GPS2 is inoperative.
GPS1 SERVICE – GPS1 needs service.
Return unit for repair.
GPS2 SERVICE – GPS2 needs service.
Return unit for repair.
NAV1 SERVICE – NAV1 needs service.
Return unit for repair.
NAV2 SERVICE – NAV2 needs service.
Return unit for repair.
NAV1 RMT XFR – NAV1 remote
transfer key is stuck.
NAV2 RMT XFR – NAV2 remote
transfer key is stuck.
G/S1 FAIL – G/S1 is inoperative.
G/S2 FAIL – G/S2 is inoperative.
G/S1 SERVICE – G/S1 needs service.
Return unit for repair.
G/S2 SERVICE – G/S2 needs service.
Return unit for repair.
GIA 63W MESSAGE ADVISORIES
Message
GIA1 CONFIG – GIA1 configuration
error. Config service req'd.
GIA2 CONFIG – GIA2 configuration
error. Config service req'd.
GIA1 CONFIG – GIA1 audio config
error. Config service req'd.
GIA2 CONFIG – GIA2 audio config
error. Config service req'd.
GIA1 COOLING – GIA1 temperature
too low.
GIA2 COOLING – GIA2 temperature
too low.
A-10
Comments
Abort approach due to loss of GPS navigation.
Displayed after passing the first waypoint of a true north approach when the nav
angle is set to 'AUTO'.
A failure has been detected in the GPS1 and/or GPS2 receiver. The receiver is
unavailable. The G1000 system should be serviced.
A failure has been detected in the GPS1 and/or GPS2 receiver. The receiver may still
be available. The G1000 system should be serviced.
A failure has been detected in the NAV1 and/or NAV2 receiver. The receiver may still
be available. The G1000 system should be serviced.
The remote NAV1 and/or NAV2 transfer switch is stuck in the enabled (or "pressed")
state. Press the transfer switch again to cycle its operation. If the problem persists,
the G1000 system should be serviced.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The G1000
system should be serviced.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The receiver
may still be available. The G1000 system should be serviced when possible.
Comments
The GIA1 and/or GIA2 configuration settings do not match backup configuration
memory. The G1000 system should be serviced.
The GIA1 and/or GIA2 have an error in the audio configuration. The G1000 system
should be serviced.
The GIA1 and/or GIA2 temperature is too low to operate correctly. Allow units to
warm up to operating temperature.
Garmin G1000 Pilot's Guide for Cessna Nav III
190-00498-01 Rev. A