Table of Contents
Advertisement
enter the IP to be changed at the network address in the configuration bar, and click Save to
change the IP.
Turn on/off the buzzer :
4 ）
on the "On" button next to the buzzer.
5 ） Turn on/off video backup :
computer ,click the "Open"button next to the video backup.
6.3-1 Switching Operation
Click the switch button and select the video option at the function button of the software interface (please
ignore the USB/Audio option).
As shown in the figure below, there is a green rectangle indicating that there is a board online. When you
switch, select "input port" and then select "output port" then click "apply" and finally click "execute".
6.3-2 Input, Output, Board Control, Resolution, Name
Change, etc.
1) Input card:
After double-clicking any input signal on the "SWITCH" interface and popping up the
interface as shown in Figure 6.3.4, you can set the input signal of the circuit. In the "control" column, we
can The equipment such as the camera connected to the circuit board is controlled (this function needs
to ask the equipment supplier for relevant information. The command sending format is shown in Table 1).
12
After ensuring that the matrix is connected to the computer, click
After ensuring that the matrix is connected to the
Figure6.3.3 Switch interface
S-MIX-PRO1600
Advertisement
Table of Contents
