Table of Contents
Advertisement
S-MIX-PRO1600
receiver etc. to the HDMI input port of the matrix.
2.Connect the output port of the matrix to HD display or HD projector with HDMI input port. Notice: It's
better to
use High-Speed HDMI Cable when the transmission distance is too long.
3.Firstly power on the signal source，then the matrix(with power supply)，finally devices connected to the
output port .
4.Plug in power to each device in the same order .
5.If all devices are connected properly, every display device should display the specified signal to make
sure the devices are
normal. If one of the displays failed to receive signal correctly, enter the menu of
display, adjust the resolution from MIN to MAX until the signal is displayed normally. A 24 Hz vertical
refresh rate may work better than 60 Hz or higher.
The following diagram is S-Mix-Pro1600 matrix switching system application:
4.Standard Packing list
Please check the outer package before using this product. Please contact us if the product is faulted or
2
Advertisement
Table of Contents
