7
Installation
Wire up the electrical connections as shown in the wir-
ing diagram enclosed with the controls.
Use the plastic clips (Fig. 14, Item 1) to fix the cable.
They provide strain relief on the cables.
Fit cover plate to controller and secure with the two
screws (Fig. 13, Item 1).
USER NOTE
Take care to ensure correct cable and capil-
lary tube routing. Do not kink capillary.
Observe the local regulations.
Route capillary tubes with temperature sensors to boil-
er well, insert and push fully home.
16
Fig. 14
Item 1: Plastic clip
Item 2: Rear panel
Fig. 15
Logano plus SB615 - Technical specifications are subject to change without prior notice.
4
1
3
Cable strain relief
Inserting temperature sensor in boiler well
2
7 747 015 037-10.1RS