Table of Contents
Advertisement
6. Basic Operation
When power is supplied, the VP6800 will boot automatically and illuminate within about 5
seconds. Use cable P/N 80159217-001. Plug the 12-pin Molex connector into the back of the
VP6800, and supply 5VDC 1.44A power (via cannon connector at the powered DB9 connection)
using an AC0005R-3 (R00111700108) or equivalent power supply. Optionally also connect a
standard Ethernet cable between the RJ45 ports on the back of the VP6800 and the network port
of the host system.
7. Installation
Mount the unit according to the drawings shown, with M3 studs spaced 65 mm apart horizontally
and 67 mm vertically.
7
Advertisement
Table of Contents
