Check Gearbox Oil - Grizzly G1071 Owner's Manual

13. Thread four of the
1
the threaded holes on each table insert, as
shown in Figure 15.
Note: The roll pins and set screws must
not protrude above the top surface of the
table insert or they will interfere with sanding
operations.
Set Screw
(1 of 4)
Flat Top Surface
Set Screws
Figure 15. Inserting set screws.
Model G1071 (Mfd. Since 11/10)
⁄ "-20 x ⁄ " set screws into
5
4 8
Table Insert
Table Insert
Roll Pin

Check Gearbox Oil

GEARBOXES MUST
BE FILLED WITH OIL!
NO OIL SHIPPED WITH
MACHINE!
Requires 80W–90W
or Equivalent
Gear Oil.
It is critical that you make sure there is oil in the
gearbox before proceeding with the test run.
Remove the spindle gearbox oil fill cap and use
the dipstick to make sure the oil level is full. When
full, the oil will read on the knurled portion of the
dipstick.
Refer to Gearbox Oil on Page 28 for more infor-
mation on gearbox lubrication, which type of oil to
use, how much to use, and where to put it.
After first two hours of operation, perform an
oil change as described in the Gearbox Oil on
Page 28.
-17-