Connecting Display, Keyboard, And Mouse - Omron SmartVision MX User Manual

Chapter 3: Installation
2. Follow the instructions in the previous section for connecting VDC to the SmartVision
MX industrial PC.
If your system has sDIO or sMI6, these need to be placed between the SmartController and the
SmartVision MX industrial PC, so the power can be daisy-chained. The SmartVision MX
industrial PC has only one 24 VDC plug. The other units have two.
If you are connecting peripherals to the SmartVision MX industrial PC, you may need to run a
dedicated 24 VDC cable to the SmartVision MX industrial PC, rather than tapping power from
the controller or your power supply. Make sure you are not exceeding the current capacity of
the controller 24 VDC plug.

3.5 Connecting Display, Keyboard, and Mouse

To connect a display to the SmartVision MX industrial PC, use either of the DVI- ports. If you
have a VGA display, you will need to use the DVI-I port with a VGA adapter.
Connect your keyboard and mouse to USB ports.
14362-000 Rev. D SmartVision MX User's Guide 21