Table of Contents
Advertisement
The SmartVision MX should be shipped and stored in the supplied packaging, which is
designed to prevent damage from normal shock and vibration. You should protect the package
from excessive shock and vibration. For environmental specifications, refer to Environmental
Specifications on page 29.
3.1 Inspecting
Carefully inspect all packaging for evidence of damage during transit. If any damage is indic-
ated, request that the carrier's agent be present at the time the package is opened.
Compare the actual items received (not just the packing slip) with your equipment purchase
order, and verify that all items are present and that the shipment is correct. Inspect each item
for external damage as it is unpacked. Contact your local Omron support immediately if any
damage is evident. See "How Can I Get Help?" section on page 15.
Retain all containers and packaging materials. These items may be needed in the future to
settle a damage claim.
Remove the SmartVision MX. Mount it near the robot.
3.2 Transport and Storage
The SmartVision MX must be shipped and stored in a temperature-controlled environment,
within the range -25 to 60°C (-13 to 140°F). The recommended humidity range is 5 to 90%,
non-condensing.
It must always be stored and shipped in a clean, dry area that is free from condensation.
3.3 Mounting the SmartVision MX
NOTE: The SmartVision MX is not intended for use in hazardous environments
(explosive gas, water, dust, oil mist) or in the presence of ionizing or non-ion-
izing radiation.
The base of the industrial PC has four tabs with holes for screwing it to a flat surface. These
are also used when mounting to a SmartController with the optional stack-mount brackets.
Regardless of the mounting method used, allow adequate space around the unit for air cir-
culation.
14362-000 Rev. D
Chapter 3: Installation
SmartVision MX User's Guide
15
Advertisement
Table of Contents
