Using A Commercially Available External Flash (Mvc-Cd400 Only) - Sony MVC-CD250 Operating Instructions (primary manual) Operating Instructions Manual

a Mount the HVL-F1000 external
flash on the hot shoe
2)
accessory shoe .
b Plug the flash into the ACC
jack.
c Turn on the HVL-F1000.
d Shoot the image.
The built-in flash does not strobes.
Using a commercially
1)
available external flash
or
(MVC-CD400 only)
You can mount a commercially available
external flash that supports hot shoe.
a Mount the external flash to the
hot shoe.
b Set the mode dial to SET UP.
c Select
[HOT SHOE] with B/v/V, [ON]
with B/v/V, then press z.
d Turn on the external flash.
For details, please consult the
operating instructions supplied with
your flash.
e Set the mode dial to M or A.
The flash also strobes when the mode
dial is set to
recommend recording with the mode
dial set to M or A when using a flash
without an auto adjustment function
(full flash).
f Shoot the image.
• Set the most appropriate aperture value
according to the guide number of the flash used
and the distance to the subject.
[SETUP 1] with v/V,
, S or SCN, but we
• The flash guide number varies according to the
ISO sensitivity of the camera, so be sure to
check the ISO number.
• The flash does not strobe when shooting in
Burst, Exposure Bracket, Twilight, MPEG
movie or Multi Burst mode.
• Note that the camera may not function properly
or may malfunction when using a flash
manufactured by another company for a
specific camera (generally a flash with multiple
contact points on the hot shoe), a high-voltage
type flash, or a flash accessory.
• When using the built-in flash or using the
optional external flash, set [HOT SHOE] to
[OFF].
85