Related Manuals for Hills Portable 120
Summary of Contents for Hills Portable 120
- Page 1 Portable Indoor Outdoor Clothesline Owner’s Manual TO SUIT MODELS: Portable Portable...
-
Page 2: Carton Contents
In this way you will benefit from all of Hanging bracket the design features and enjoy safe use Door adaptor of the product. Line Thank you for choosing Hills. Accessory pack Smart pegs Warning Accessory Pack Contents • Do not allow children or pets to swing on Part name Qty. - Page 3 Assembly The Hills Portable Clothesline is quick and easy to assemble. Just follow the steps below which are suitable for both the 170 (10 line) and 120 (8 line) models. NOTE: all diagrams in this manual show the Portable Clothesline 120.
- Page 4 Assembly 2. Attach the Legs to the Hinge Assemblies. Fasten the legs as shown in Steps 1–4. Step 1 Step 2 Mount hole Locking wedge and locking nut Locate the locking wedge (with M6 nut assembled) While holding the locking wedge in place, fit leg tube on to the moulded leg section of the hinge moulding.
- Page 5 Assembly 3. Attach the Brace to the Legs. Using the eight (8) M6 x 16 countersunk screws, attach the leg brace to the four (4) threaded inserts in the legs using the hex key - 4mm. Fasten securely. Repeat at other end. Threaded insert Leg brace M6 x 16 countersunk screws...
- Page 6 Assembly 5. Attach the arms. Locate the arms into the recess in each end of the hinge assemblies ensuring the screw holes and insert fasteners align. Insert the two (2) M6 x 12 low profile screws and fasten securely using the hex key – 4mm. NOTE: Ensure the arms are assembled with the curve up (as shown).
- Page 7 Assembly 6. Attach the line. A. Fasten the line to the innermost line tensioner as shown in steps 1–4. Step 1 Step 2 Fit the cover cap onto the end of the line, (ensure Insert the line down through the front slot of the correct orientation).
- Page 8 Assembly C. Continue to thread the line through each of the line sleeves ensuring all lines are parallel, as shown in step 6. Step 6 Line tensioner inner Line sleeve Line tensioner outer Cover cap D. Tie off line to the outer line tensioner as per steps 1–4 on page 7. Do not tighten line yet.
- Page 9 We recommend trimming excess line after a few NOTE: A short video showing the attachment of loads of washing have been hung to allow ‘pre- line segments is available for viewing on the Hills stretch’ of line to occur. website: www.hills.com.au Your Portable Clothesline is now ready to use.
-
Page 10: Folding And Unfolding
Folding and Unfolding Folding and Unfolding A. To fold away your Portable Clothesline, pull the latch out with one hand, while supporting and rotating the legs up and around with your other hand. Keep rotating until the latch ‘clicks’ back into place, locking the legs closed. B. - Page 11 Accessories Hanging bracket To hang your Portable Clothesline for convenient storage a hanging bracket has been included. 1. The hanging bracket can be fastened to almost any wall or vertical surface using appropriate fasteners (not supplied). 2. The hanging bracket and door adaptor can be used over most doors. Simply place the hanging bracket and door adaptor over your door as shown.
- Page 12 Accessories Wind tether When you use your Portable Clothesline outdoors (particularly on balconies) we recommend using the wind tether. Secure the clothesline to a fixed object like the balcony, a post or a railing to ensure it does not blow away. NOTE: 1.
- Page 13 Hills Smart Pegs We have included a ten pack of Hills Smart Pegs for use with your Portable Clothesline. Hills Smart Pegs are UV resistant and can be left outside without severe deterioration occurring. They are dual moulded for superior comfort and grip. Hills Smart Pegs can be purchased at most hardware and general merchant stores.
-
Page 14: Care And Maintenance
Portable Clotheslines. We recommend tear or damage. If there is any damage, placing them over the inner lines leaving parts should be replaced with original Hills the outer lines for smaller objects. We spares or the Clothesline repaired before also recommend spreading the load over using again. -
Page 15: Guarantee And Contact Details
Unless any addition or attachment to this product has Hills specific approval or is sold as a Hills product the warranty on this product is waived. The product is designed to perform a specific task under established... - Page 16 Hills Industries Limited A.B.N. 35 007 573 417 Issue February 2009 PD1711d...